ماژول درایور موتور L298N
این ماژول یک درایور موتور با قدرت بالا برای راندن موتورهای DC و Stepper است. این ماژول از یک آی سی درایور موتور L298 و یک رگولاتور 5 ولت 78M05 تشکیل شده است. ماژول L298N می تواند تا 4 موتور DC یا 2 موتور DC را با کنترل کردن جهت و سرعت آن ها راه اندازی کند.
پیکربندی پین اوت ماژول L298N
نام پین |
شرح |
IN1 & IN2 |
پایه های ورودی موتور A. برای کنترل جهت چرخش موتور A استفاده می شود |
IN3 & IN4 |
پایه های ورودی موتور B. برای کنترل جهت چرخش موتور B استفاده می شود |
ENA |
سیگنال PWM را برای موتور A فعال می کند |
ENB |
سیگنال PWM را برای موتور B فعال می کند |
OUT1 & OUT2 |
پایه های خروجی موتور A |
OUT3 & OUT4 |
پایه های خروجی موتور B |
12V |
ورودی 12 ولت از منبع تغذیه DC |
5V |
برق مدار منطقی سوئیچینگ را در داخل آی سی L298N تامین می کند |
GND |
پین زمین |
برنامه های کاربردی
- درایو موتورهای DC
- موتورهای پله ای را به حرکت درآورید
- در رباتیک
Brief about L298N Module
The L298N Motor Driver module consists of an L298 Motor Driver IC, 78M05 Voltage Regulator, resistors, capacitor, Power LED, 5V jumper in an integrated circuit.
78M05 Voltage regulator will be enabled only when the jumper is placed. When the power supply is less than or equal to 12V, then the internal circuitry will be powered by the voltage regulator and the 5V pin can be used as an output pin to power the microcontroller. The jumper should not be placed when the power supply is greater than 12V and separate 5V should be given through 5V terminal to power the internal circuitry.
ENA & ENB pins are speed control pins for Motor A and Motor B while IN1& IN2 and IN3 & IN4 are direction control pins for Motor A and Motor B.
Internal circuit diagram of L298N Motor Driver module is given below:
Applications
- Drive DC motors.
- Drive stepping motors
- In Robotics
نقد و بررسیها0
هنوز بررسیای ثبت نشده است.